PIX 515 DMZ Configuration

[adam]

i am not sure what is causing this problem. I have a PIX 515 with Three Interfaces. I can communicate between the inside and the outside, but have no way of communicating between the inside and the DMZ or the outside and the DMZ as if my DMZ interface is down, I know it is up since I can ping servers on that side only from the DMZ interface.

Am I missing a route statment somwhere ??

Any suggestions are greatly appreciated

[rrbleeker]

Adam,

Could you provide us with the nat, global, static and access-list (or conduit) commands? You can replace real addresses with fake addresses.