Hi
I have erased my Cisco PIX 515 E flash.I was able to boot the system but there is no bootable image in the flash,How can I configure my PIX to write image to flash.
This is the paste from my running config and flash
pixfirewall# sh run
: Saved
:
PIX Version 8.0(2)
!
hostname pixfirewall
enable password 8Ry2YjIyt7RRXU24 encrypted
names
!
interface Ethernet0
no nameif
no security-level
ip address 192.168.0.2 255.255.255.0
!
interface Ethernet1
no nameif
no security-level
ip address 192.168.1.10 255.255.255.0
!
interface Ethernet2
shutdown
no nameif
no security-level
no ip address
!
passwd 2KFQnbNIdI.2KYOU encrypted
ftp mode passive
pager lines 24
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
dynamic-access-policy-record DfltAccessPolicy
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
no crypto isakmp nat-traversal
telnet timeout 5
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
!
!
prompt hostname context
Cryptochecksum:dd682b52feb48c7172e69d906fd0de0d
: end
===============
from flash
pixfirewall# sh flash
Directory of flash:/
9 -rw- 1232 19:22:58 Mar 03 2017 startup-config
15998976 bytes total (15992320 bytes free)
Any and every help would be apperciated.
Thanks
