Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi
Sorry to all,I changed my router and i can not again connect to internet.I have done the configuration as i did before but this time i am missing some thing there is again no internet access.
please have a look at the following configuration and...
Hi
I have erased my Cisco PIX 515 E flash.I was able to boot the system but there is no bootable image in the flash,How can I configure my PIX to write image to flash.
This is the paste from my running config and flash
pixfirewall# sh run: Saved:PI...
Hi
1-I am trying to upgrade IOS for my cisco 2811 router.When i try to downlaod it gives me error of service contract.Do we need to buy new router as mine is eol.
Any help would be apperciated.
thank you
arif
Hi
I am new to networking.I have got a cisco 2800 series router and I configured nat.I can ping domains and have full internet connection on all interfaces but any device such as LAPTOP can not connect to internet.IP NAT works fine ,Please have a lo...
Router#ping 8.8.8.8
Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:.....Success rate is 0 percent (0/5)Router#
I had to uncheck the option of blocking fragment IP on modem.
Changing the modem into bridge mode didn't help.
Also I had to open ports from 1 to 65536 on my isp modem ,there is full connectivity but still ping to 8.8.8.8 doesn't work.
i hope it he...
