Hello,
I am having the following problem on my Cisco PIX 515:
I had been running:
- Cisco Secure PIX Firewall Version 6.0(1)
- PIX Device Manager Version 1.0(1)
- Hardware: PIX-515, 32 MB RAM, CPU Pentium 200 MHz
- Flash i28F640J5 @ 0x300, 16MB
- BIOS Flash AT29C257 @ 0xfffd8000, 32KB
I upgraded the PIX to pix622.bin. That seemed to work, but the PIX did not boot after reload.
So I reverted it to pix601.bin.
That seemed to work, and my configuration file was still in place and all my services worked as before.
However, upon reload I get the following error:
Reading 2445824 bytes of image from flash.
32MB RAM
imgsum_config: sumval(0x1f8e) md5(0x95937073 0x75b817db 0x54d7811a 0xba7d0214)
imgsum_verify: chksum(0x 0) md5(0xf9d77cec 0xfca32e88 0xb13f21e9 0xfa81733b)
Panic: kernel - The checksum verification for this image failed.
Thoughts? Help?