Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
303
Views
0
Helpful
1
Replies

pix 515e

W-Robinson
Level 1
Level 1

‎10-01-2003 10:30 PM - edited ‎02-20-2020 11:01 PM

when i do a sho int i can see my e0 and e1 but i

cannot see the other four int on my quad card..

what do i do to see those int to config them?

thanks.....

0 Helpful
1 Reply 1

scoclayton
Level 7
Level 7

‎10-02-2003 05:26 AM

Hi,

You should see the 4 other interfaces for the quad card in the 'sh int' output. Nothing other than seating the card is needed. Can you post a 'sh ver'?

Scott

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card