I have a 525 bundle but one of the firewalls will not boot up anymore. It gets to a certain point and then just hangs. These two firewalls were just recovered from a client site so I'm guessing at this point what may have happened. Is there a typical cause for this type of issue when the boot up just hangs? Below is all I see when consoled into the pix during boot up.
CISCO SYSTEMS PIX FIREWALL
Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73
Compiled by morlee
256 MB RAM
PCI Device Table.
Bus Dev Func VendID DevID Class Irq
00 00 00 8086 7192 Host Bridge
00 07 00 8086 7110 ISA Bridge
00 07 01 8086 7111 IDE Controller
00 07 02 8086 7112 Serial Bus 9
00 07 03 8086 7113 PCI Bridge
00 0D 00 8086 1209 Ethernet 11
00 0E 00 8086 1209 Ethernet 10
00 11 00 11D4 2F44 Unknown Device 11
00 13 00 1011 0026 PCI-to-PCI Bridge
01 00 00 8086 1229 Ethernet 11
01 01 00 8086 1229 Ethernet 10
01 02 00 8086 1229 Ethernet 9
01 03 00 8086 1229 Ethernet 5