Pix access through a Linux Bridge on wireless network

[rfulgram]

I have a pix that I am adding to a new network we are building. It needs to connect to the internet through the ISP's birdge which is a Linux box and is a wireless connection.

I added a nat, global and default route on the pix. I can get out from the pix to another system on that gateway, but I cannot get the host to browse a web page either by URL or IP address.

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.