Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having trouble getting a connection to a providers lucent wireless bridge with our Cisco Aironet 350. I can see his device if I do an antenna test and we both have MAC address applied to his access list and in the Aironet bridge and the SSID is...
I have a 350 bridge and am trying to utilize it to connect a site with their wireless ISP. The ISP has given me one IP address and I wanted to place that on the Radio side of the bridge and a private network on the ehternet side of the bridge and be ...
The 3550G comes with 10 module ports, Is there a fiber module for one of the ports that supports fiber at 100mbs or can you only get the Gbic modules that support fiber 1000 only?I have a remote site that I need to use fiber on and am looking for a M...
I am testing a Pix prior to configuring IPSEC settings on the outside interface. The folks I am working with need to be able to Ping the outside interface of our Pix. I cannot figure out what I am missing that will not allow me to ping the outside i...
I have a pix that I am adding to a new network we are building. It needs to connect to the internet through the ISP's birdge which is a Linux box and is a wireless connection. I added a nat, global and default route on the pix. I can get out from the...
Thanks, I checked on the other device. It is an Orinoca AP1000. The ISP put both MAC addresses of the 350 in there list, and according to the vendor web site the AP1000 is Wi-Fi compliant. I am using 802.11 and have tried the bridge set as non-root w...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note --I...
I have a route that is setup by the Pix 66.45.121.0 255.255.255.0 66.45.121.1The 66.45.121.1 would be the outside interface of the Pix. I have 3 more active interfaces on the PIX the outside one is not my default path to the internet for my other ...
Yes I can ping both the inside and outside of the router. And I can ping the outside interface of the pix from the router. I just cannot ping the outside interface of the pix from the internet.
