pix and policy routing?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2003 12:58 AM - edited 02-20-2020 11:07 PM
Hello,
is there a possibility to configure a policy routing at the pix firewall.I want to configure a policy routing at the pix that only traffic from a special IP address routes over a special gateway all other traffic should use the default standard gateway.If I use the route-map command together with the match ip address acl and set ip next-hop,I get the the error message that these command do not support extended access-lists.
How can I generate a standard access-list at the pix?
Somebody told me that the route-map command support only a redistribute OSPF routes.
Thanks for your answer.
- Labels:
-
Other Network Security Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2003 06:11 AM
Policy Based Routing is not supported on the PIX.
Harold Ritter, CCIE #4168 (EI, SP)
