PIX configuration with DSL router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2005 06:12 PM - edited 02-21-2020 12:10 AM
Hi,
I am new to PIX.
Pls find the attached setup diagram and configuration.Customer using ADSL modem and Linksys router.ISP have given two IP address(200.a.b.c for mail.xyz.com) and 200.x.y.z public IP on PIX external interface for outgoing traffic.
The customer has internal mail server and users should be able to send and receive email.Apart from this the customer has another mail server hosted somewhere and users should be able to send and receive email using outlook express.
Pls find the diagram and PIX configuration. and suggest whether it is correct?
Do the needfull guys.
Regards,
Prashanth
- Labels:
-
Other Network Security Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2005 11:40 PM
prashanth,
Find attached modified configuration for your pix, after you have made the modifications make sure to save with : write mem and also issue : clear xlate
I have only given access to e-mail service only for the moment, we can work on the other services when this is up and running!!
Hope this meets your requirements and please rate all post!
Good luck,
Jay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2005 11:42 PM
PS.
Also forgot to mention that, public IP address for e-mail MUST correspond to the IP address for your MX record, i.e. MX record IP points to that IP address!!
Jay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2005 11:56 PM
Hi Jay,
will get back to you.
Mx = private IP or public ip?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-27-2005 12:00 AM
MX = Public IP !!!
Jay
