- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-27-2003 11:46 PM - edited 02-20-2020 10:57 PM
Dear Forum,
our software is tunneling data (rpc-calls etc.) using http to go through firewalls on port 80.
One of our customers has a pix. The pix is removing the content from our http-requests.
We found that out, using a packet sniffer. We checked the packet befor it entered the pix
and checked how it came out.
We don't have access to configure this pix, that's done by another comany.
I am thingking about getting another customer a pix, but I want to make sure, that the pix is not messing up our traffic. Is it possible to disable this functionality?
Thank you!
Regards
Christian
Solved! Go to Solution.
- Labels:
-
Other Network Security Topics
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2003 02:30 AM
i think you should test your software with the configuration on the pix with "no fixup protocol http 80"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2003 02:30 AM
i think you should test your software with the configuration on the pix with "no fixup protocol http 80"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2003 11:06 PM
thank you! this should help:)
best
christian
