Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Forum,I just bought the 831 Imagec831-k9o3sy6-mz.123-4.T2.bin to do DMVPN. Everythingworks fine, but after one or two days the routerruns out of memory. I observed this problem with sh proc memory and the memory is decreasing every hour a little...
Dear Forum,I am doing ezvpn between our HQ and the BO using network extension mode. Sometimes the HQ has no ipsec sa any more, but the BO still has one and thinks it is connected.Wo can a sa get lost? The BO is disconnected by the ISP evry 24h Best,...
Dear Forum,why shoud the trafic profile be 80% spoke to hub and only 20% hub to hub using DMVPN?Is there a reason? We plan to have 220 spokes. Some will do windows terminal servies between each other (sometimes), but the most of them (190) will only ...
Dear All,I have a 831 (HQ) which has a static IP and a Soho91 (BO) which has adynamic ip (xDSL).Is there a way to build up the tunnel automatically from the BO thethe HQ, that the HQ can access data in the BO?The only way I found is to configure the ...
Dear Forum,our software is tunneling data (rpc-calls etc.) using http to go through firewalls on port 80.One of our customers has a pix. The pix is removing the content from our http-requests.We found that out, using a packet sniffer. We checked the ...
Hello Jan,no, cisco is not working with dynamic ip-addresses on both tunnelendpoints and I think there are enough reasons why.Actually there is one way to do it anyway, but the feature is not intended to this!You can use the ez-vpn feature. There you...
Dear Afaq,thank you for your reply. EZVPN looks like the bestway to solf my problem. Is it posible to do spoke to spoke communication between the ez-vpn clients?ThanksChristian
Thank you for your answer! IKE seems to use hostnames instead of ip-adresses, but "set peers hostname" always resolvs the hostname and writes the ip-address in the config. Somthing must be still wrong....?!RegardsChristian
