PIX interfaces ????

[afzaalq007]

hi

we are configuring a PIX 525 and facing a prob that after assing the Ip add to an interface we have observed that interfce is administravitivly Down what can i do,,

I have read on cisco site intsert new card in it and than use write mem for it i could nt unserstand it .. can you tell us abuot it..

which new card ????

Thanks and regards

[vijayasankar]

Hi,

By default all the interfaces will be in shut state in the configuration.

Try issuing "no shut" on the interface configuration mode and saving the configuration.

-VJ

[talisman1310]

doind a no shut in the particular interface will not work for a firewall.

Try the following syntax....

interface < hardware_id>

eg:

interface ethernet0 100full

interface ethernet1 100full