Hi All,
Here is how my setup looks like
I have a Cisco VPN Concentrator 3030 at my central locations, where my management servers are located. These management servers are supposed to monitor network devices at all remote locations. I have a PIX 501 at the other end, which has an IPSec tunnel with this VPN Concentrator 3030. I have following two management requirements -
1/ From some management servers, I want to reach the remote managed devices, using their original IP Addresses.
2/ From some management servers, I want to reach the remote managed devices, using their NATed IP Address.
This requirement seems a bit strange, but this is how it is. I have configured a static (inside, outside) command for doing this.
When I configure static command, I can reach the managed device using its NATed IP address, but I can no longer reach the device using its physical IP from the other side of the tunnel. Can anyone help me with this problems.
Please let me know if you need any addiiotnal information abt this setup
