Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Here is how my setup looks likeI have a Cisco VPN Concentrator 3030 at my central locations, where my management servers are located. These management servers are supposed to monitor network devices at all remote locations. I have a PIX 501 at...
Hi Guys,I am trying to establish an IPSec VPN tunnel between PIX 501, and VPN Concentrator 3030. I am following this cisco document for the same -http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtmlI ha...
I have following network connectivity -Client network --> Client Checkpoint firewall --> IPSec tunnel --> Cisco 3000 VPN Concentrator --> PIX Firewall --> NMS Server LANUsing this connection, I am doing SNMP Management for all client network devices....
If you have two routers, and two serial links of same speed connecting them, then OSPF or EIGRP will automatically do the load balancing between these two links. If the links are of different speeds, then you can configure load balancing by using EIG...
You can use exit interface in your static route command, when you have point to point links. You can not use it in multi access interface (like ethernet, where there are lot of machine connected to the same segment). You should also NOT use exit inte...
I would like to add to the information provided here. ip default-gateway command can also be used in the cisco routers, when the IP Routing is turned off. There routers just act like network hosts.This information is available in the BSCN coursebook,...
