Pix Packet/Protocol decode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-24-2001 07:54 AM - edited 02-20-2020 09:49 PM
Hi ,
I'm having problems getting a Pix firewall to do a packet/Protocol decode of the packets hitting my firewall just to have granular info. regarding what is happening on the network from the internet. Is this possible if yes how? if not then this is something cisco should look at implementing in any upgraded version of code .
- Labels:
-
Other Network Security Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2001 02:16 PM
I'm not sure I understand the question. there is a debug packet command, But, on a busy network, depending on what you wish to decode, it can consume some resouces. What is it you want to decode?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2001 08:23 AM
If you are looking for information on you network, I would use a sniffer instead of using debug on the PIX. Debug is really meant for troubleshooting purposes and not for baselining. Like Vince mentioned, debugging can take a significant part of the available resources.
