PIX Routing

[jcleary]

Hi,

I have a PIX 515 as my default gateway and i need to route some traffic to another router. does the PIX support Static routing yet. Its 6.3.(4)

Thx

[haydenmace]

in short yes, it has supported this for quite some time.

just use the route command

Cheers

[mehrdad]

Hi,

yes it supports but be aware the PIX does not route traffic received on one interface back out the same interface (6.3)

the below link explains static route with the one Cisco PIX and two routers :

http://www.cisco.com/warp/public/110/20.html

[jcleary]

so basically i have a PIX we will call the ip 10.10.10.1 Which is everyones Default gateway i need traffic thats destined for 10.20.1.0 to go to router 10.10.10.2. so all i need is

route insice 10.20.10.0 255.255.255.0 10.10.10.2