PIX sh crypto isakmp sa

[m-raft]

I have a site to site VPN using PIXs at both sites. When I do a sh crypto isakmp sa I do not see the tunnel established. I do see traffic being encrypted between the two peers both with debug packet and sh crypto ipsec sa. I have done numerous installs using this type of scenario but have always seen the tunnel endpoints when using the sh crypto isakmp sa command. Has anyone else seen this type of behavior on the PIX. I am running 6.01 and the traffic is being encrypted so it's not a huge problem but I would like to look at the tunnels that are established since I have multiple tunnels defined.

Thanks in advance

Mike

[smahbub]

I haven’t seen that. I wonder if it’s a bug on 6.0(1). Have you talked to Cisco yet? Come back and let me know what you come up with.