I have PIX 506e at office and NetGear FVS318 at home. I can create a VPN connection between the two (initiating it from the PIX as the PIX sits behind a SMC router that does not allow VPN traffic to originate from outside). I'm sure I have a VPN connection because on the PDM graphs, I see IPSEC and IKE tunnels that have been created and a status of QM_IDLE. My problem is that I cannot do anything across the tunnel I can ping from either network all day long and never get a reply back. I cannot see my office terminal server from my home computer. Below is my PIX listing. Passwords between the two devices are correct, as are the encryption/authentication/etc... settings.
my config file is attached
Any help would be appreciated.
Also, as my FVS318 outside IP is dynamically assigned, is there a way to configure the pix to look for a dynamic VPN host?
Thanks