Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have PIX 506e at office and NetGear FVS318 at home. I can create a VPN connection between the two (initiating it from the PIX as the PIX sits behind a SMC router that does not allow VPN traffic to originate from outside). I'm sure I have a VPN c...
I have been using my PIX 506e with a outside IP address assigned via DHCP. My PIX sits between the building's router and my network switch. The router administrator has assigned me a static IP address. When I change the outside IP address from dyn...
Below are the requested 'show' command outputs. show ipSystem IP Addresses: ip address outside 192.168.1.103 255.255.255.0 ip address inside 10.0.0.5 255.0.0.0Current IP Addresses: ip address outside 192.168.1.103 255.255.255.0 ip address inside 10....
Thanks for your responses.I got some information from the building router:WAN IP: 64.x.x.74Gateway IP: 64.x.x.209DNS: 64.x.x.5Seondary DNS: 64.x.x.6I used both CLI and the Conf t commands and entered the following:route outside 0.0.0.0 0.0.0.0 64.x....
Peter,I tried what you suggested. Still no go. Below are 2 listings of the PIX config. This version fails w/ a statically defined IP on the outside.PIX Version 6.2(2)nameif ethernet0 outside security0nameif ethernet1 inside security100enable passwo...
