Hi,
I need to create 2 VLANs off the inside interface, say VLAN 1 and 2. I set up a switch port to trunk only these VLANs (native VLAN is 1).
I cannot get the pix to communicate on VLAN 1 with other devices in that VLAN. My config looks like the following:
interface e1 vlan131 physical
interface e1 vlan1 logical
nameif vlan1 MANAGEMENT security90
ip address inside 10.0.131.2 255.255.255.0
ip address MANAGEMENT 10.0.128.1 255.255.255.0
I also tried it without the first line to no avail.
Any ideas what I am doing wrong here? Based on the config guide for 6.33 this should work. I also tried it without the first line.