Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to connect my PIX w/ GE port to a 3560 SFP. Both are multimode. I know the PIX is a standard SC connector but I am unsure whether I can connect a standard SC to SC cable to the GLC-SX-MM= adapter on the 3560. Please let me know ...
Hi,I am trying to let the remote pc access the internet via w/o tunneling the traffic to the PIX and tunnel only traffic to the PIX destined for the LANs behind it.I am confused on the use of the splt tunnel acl and if there is a need for client conf...
Hello, Below is trimmed output from show module.Mod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ------------------- --- --------1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE...
I would like to authorize groups and users against an acs server. I am having trouble understanding what needs to be set on the concentrator and acs server.On the concentrator I have configured the acs servers globally as authorization servers. The...
Use wireshark to look for a CDP announcement from the switch... it has the managment address in the data. Reconfig your adapter and connect w/ browser... worked for me -- could wipe config.
Hey BH2020. I just wanted to say THANKS!! for answering your own question. I have been bashin my head in for about 1 month with cert authentication for vpnclient and sslvpn. I wish TAC documentation was remotely as clear as yours.
Hi Georg,I aded the ip to the standby 3550 as you suggested and it worked. Thank you very much! I was going by the following passage in a Cisco Document:http://cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a008...
Thank you for your reply.The L3 switch is uplinked over ethernet to an ISP who is routing 4 /24's through it to the PIX. I cannot supernet these ranges as they are not contiguous. I must be able to route outbound initiated connections, via all range...
