cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
228
Views
0
Helpful
4
Replies

Polling snmp oid for power supply on cisco 2140

vgershman
Level 1
Level 1

I am not able to run snmp walk command for power supply and fan status against Cisco 2140 firewall. I use 1.3.6.1.4.1.9.9.826 oid. 

4 Replies 4

marce1000
VIP
VIP

 

       - What does 'not able' mean = what are your results ?

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

I get "no such object available"

 

  - Usually means that the OID and or feature is not (yet) implemented you may verify using :
                 > system support diagnostic-cli
  firepower# show snmp-server oid

  or stuff like :

firepower# connect fxos

firepower(fxos)# show snmp internal oids supported

 

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

ok. got it. will check that. thanks

Review Cisco Networking for a $25 gift card