Port Channel of Subinterfaces in FTD

[sv7]

Hello All,

Is it possible to do port channel of Subinterfaces in FTD. Please find attached figure where i will bundle port ethernet1/3 (contains subinerfaces 1/3.1, 1/3.2)  with ethernet port 1/5 (will replicate same configuration as of port ethernet 1/3) and connect both these to Switch running Lacp in Trunk mode.

Please help. 

[Marvin Rhoads]

Yes you can - but you will have to remove and replace the current subinterfaces in order to do that.

In other words, it will be a disruptive change.

[sv7]

Means i have to do the port bundelling (port eth 1/3 and 1/5) and then configure subinterfaces ?. Or with port bundelling its not possible to do subinterfaces ?.

Pls me in understanding 

[Marius Gunnerud]

You first configure the portchannel and then configure the subinterfaces.