11-28-2013 05:59 AM - edited 03-11-2019 08:10 PM
hi
i have a problem to login to my ASDM console on my ASA 5510.
when i reach the http server via http 192.168.1.1 i receive this message
can you help me?
ASA version 913-k8
ASDM version 714
see my config please
Solved! Go to Solution.
11-28-2013 06:07 AM
enable
config t
no http authentication-certificate management
Also get me a show version and a show run all ssl
Value our effort and rate the assistance!
11-28-2013 07:38 AM
Ok, log in through CLI and configure the next:
enable
config t
username admin password admin123 pri 15
aaa authentication http console LOCAL
You can create that username I mention or what ever username you want just set the privilege to 15
Value our effort and rate the assistance!
11-28-2013 06:05 AM
What is the source IP address from where you are trying to access the ASA over ASDM
Value our effort and rate the assistance!
11-28-2013 06:07 AM
enable
config t
no http authentication-certificate management
Also get me a show version and a show run all ssl
Value our effort and rate the assistance!
06-28-2015 02:16 PM
updated my ASA from 9.1.2 to 9.4.1 - and I ran into this same issue. That no http auth-cert mgmt helped. Thank you.
04-03-2018 10:24 PM
Thanks for the quick tip, I ran into a similar issue and was able to fix following your guide.
Appreciated!
06-28-2018 09:44 AM
Thanks for your help!!!
11-28-2013 06:31 AM
ok
now it works, but i have a login failed when i try to login with
enable_15
and my enable password
11-28-2013 07:38 AM
Ok, log in through CLI and configure the next:
enable
config t
username admin password admin123 pri 15
aaa authentication http console LOCAL
You can create that username I mention or what ever username you want just set the privilege to 15
Value our effort and rate the assistance!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide