Problems with NTP and set clock ASA 5585

[RAUL1784]

Hi all,

We have problems to change hour my device. We try put command npt in conf t but it´s not permited. And command clock also isn´t permited.

Device is ASA5585-SSP-10 and him version is Software Version 9.6(3)9.

This ASA have two contexts but in both contexts we have same problem.

ciscoasa(config)# ntp
^
ERROR: % Invalid input detected at '^' marker.
ciscoasa(config)# ntp?
ERROR: % Unrecognized command

ciscoasa# clock ?
ERROR: % Unrecognized command
ciscoasa# clock

thanks so much in advance,

BR

[esenuniez1]

Hi Raul!

I hope you´re doing well.

You must to change the context to "System context", and in this context, you can configure NTP and set clock.

Tell me if you have any problem.

Regards!