RADIUS NAT on ASA55xx

[salberink]

Hi,

I'm looking towards procuring some ASA55xx as firewall for a datacenter deployment. However, for this deployment to work, I need the ASA to do a NAT translation between 2 networks. I will be receiving an incoming Radius accounting request stream for which I can NAT the IP-address present in the Radius request. Is this possible on the ASA? If so: how do I configure this?

Best regards,

Sander

[vijayasankar]

Hi Sander,

You can very well do this static nat.

Have a look at this URL (which has examples )for more information on how to configure the same.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f31a.shtml#s11

Hope this helps.

-VJ