cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

478
Views
0
Helpful
1
Replies
Highlighted
Beginner

Re-convergence does not work on FTD

Hi Forum,

 

we have a pair of FTD2140 running patch 6.4.0.4 in HA setup. Default HA timer are used. Re-convergence does not happen after a failover. All interfaces are in "normal" status when doing "show high-availability config" from CLI. Is this behavior per design? I was expecting re-convergence when interfaces are back up again.

 

Thanks,

Frode

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

I'm informed that this is per design. Case closed.

View solution in original post

1 REPLY 1
Highlighted
Beginner

I'm informed that this is per design. Case closed.

View solution in original post

Content for Community-Ad