cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
413
Views
0
Helpful
1
Replies

Reload ASA with Module IPS

Juan Ibañez
Level 1
Level 1

I have  ASA in Cluster (Failover) and i have a question, when shutdown module IPS (hw-module 1 shutdown) and reload the ASA Chassis, the module will start?

how configure this module  to shutdown forever?

Cisco have any document for this situation.

 

 

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

The hardware module will always initialize on power cycle. You'd have to physically remove the IPS SSP and replace it with a slot tray (to ensure proper airflow) if you want to have it gone altogether.

However, if there's no service-policy in the ASA configuration redirecting traffic to it, it won't be in the flow of traffic.

View solution in original post

1 Reply 1

Marvin Rhoads
Hall of Fame
Hall of Fame

The hardware module will always initialize on power cycle. You'd have to physically remove the IPS SSP and replace it with a slot tray (to ensure proper airflow) if you want to have it gone altogether.

However, if there's no service-policy in the ASA configuration redirecting traffic to it, it won't be in the flow of traffic.

Review Cisco Networking for a $25 gift card