12-09-2013 02:50 PM - edited 03-11-2019 08:15 PM
Hello Support,
I have a question regarding a remote access VPN setup with the following. I have a Cisco 6500 with multiple VLANs, and an FWSM setup in mutliple context mode. Each of our clients sits behind their own context, and has their own associated VLANs. Each context has a shared interface, so that one network (our management network) can see all of the networks. We are using a Cisco ASA to terminate P2P VPNs as the FWSms cannot do so, but I would like to setup a remote access VPN from the ASA, but I will need to connect in and have access to all networks. Currently the ASA has an outside interface for internet, two client inside interfaces, and one interface on the shared network.
If I setup a remote access VPN from the ASA with a separate scope will I be able to see all the networks that I setup routes and nonats for or is there more to it?
I provided a brief diagram showing all the vlans, I will need to be able to access all of the 6500s vlans when connected using the VPN.
Thanks in advance for all ideas, suggestions, and assistance.
Solved! Go to Solution.
12-09-2013 04:56 PM
Hello John,
You will need to configure the respective IP Address pool for the Anyconnect users,
Then create the no_nat rules from all of the internal subnets to the Anyconnect Pool.
That should do it bud . I mean just make sure the internal network (core) knows that in order to reach the anyconnect pool must send the traffic to the ASA.
Rate all of the helpful posts!!!
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
12-10-2013 09:02 AM
Hello,
Cool,
Keep us posted and remember to rate all of the posts
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
12-09-2013 04:56 PM
Hello John,
You will need to configure the respective IP Address pool for the Anyconnect users,
Then create the no_nat rules from all of the internal subnets to the Anyconnect Pool.
That should do it bud . I mean just make sure the internal network (core) knows that in order to reach the anyconnect pool must send the traffic to the ASA.
Rate all of the helpful posts!!!
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
12-10-2013 08:02 AM
Thank Julio.
I have an outage this weekend, that I'm doing a few other things, so I will bring it up then and let you know if any issues come up, thanks!
12-10-2013 09:02 AM
Hello,
Cool,
Keep us posted and remember to rate all of the posts
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide