Reset PIX 501to Factory Defaults?

[lynne.meeks]

How does one reset the PIX 501 to factory defaults when you do not have the enable password?

Thanks!

[JORGE RODRIGUEZ]

You will need to do the password recovery as reseting to factory defaults requires to be in enable config mode.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml

after you recover password then issue the command.

example

PIX(config)#configure factory-default

HTH

Jorge

[lynne.meeks]

Thanks- that's exactly what I was looking for.

I knew it had to be out there somewhere, but I just couldn't locate it.

I am all set now; thanks again.

[JORGE RODRIGUEZ]

Lynney,

You're welcome, if problems let us know.

Rgds

Jorge

pls rate any helful post