02-11-2019 08:35 AM - edited 02-21-2020 08:47 AM
Hi all,
I’m finding it hard to get information on the best way to do a restore of 2 ASA's in HA mode.
Imaging the config on both ASA's are bad and you don't have the time to unpick the config to remove all that you did over the last few days.
You have a backup of both primary and secondary from a few days ago that you would like to restore to.
I have found a post where someone explains the steps (below)
"The easiest way to do this would be to first apply the config on secondary and make the secondary unit active and then do a write on secondary once it’s active, then the secondary which is now active will push the config to former active restoring config there as well"
We have tried this method but once you apply the config to the secondary\standby, it immediately pulls the bad config from the primary\active.
How do you stop the standby pulling the active config ?
Thanks in advance.
02-11-2019 10:16 AM
02-11-2019 02:32 PM
Another approach could be to power down the secondary unit, restore the config to the primary unit, then power the secondary unit back up.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide