02-06-2017 12:15 AM - edited 02-21-2020 06:00 AM
Hi,
I didn't find any documentation how to restore a failed FTD, for example after a hardware RMA or a failed upgrade, as in my case.
I've already reimaged the FTD and want to re-register it with the FMC. It's part of a failover pair too in our case.
02-06-2017 07:08 AM
Please see the below urls for reference which might be helpful.
http://www.cisco.com/c/en/us/td/docs/security/firepower/601/configuration/guide/fpmc-config-guide-v601/fpmc-config-guide-v601_chapter_01100110.pdf
http://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/200868-Configuring-Firepower-Threat-Defense-FT.html
Similar thread
https://supportforums.cisco.com/discussion/13127371/ftd-registering-fmc-scenario
Hope to help.
02-06-2017 07:53 AM
Thanks for the pointers, especially the HA replacement section!
I looked in the backup/restore section.
What would you do for a single FTD?
Breaking the failover pair didn't work because of an error in FMC.
I re-imaged both units with 6.2, reconfiguring all interfaces, routes, applying policies took a while but it works again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: