RME 4.3.1 Compliance Job deploy timeout on GUI

[tim.cooper]

Got a strange issue with RME 4.3.1 where it timeouts if I try and deploy a compliance job to a group of more than about 1500 devices. I get right to the finish screen of the deploy job and then it sits there for ages and finally appears to timeout in some form and the job is never created? If I take a smaller chunk of the same devices, it works fine?

Any ideas as this is really causing an issue with a global deployment at the moment.

[tim.cooper]

Perhaps I should have also confirmed that it only occurs if I seperate out the compliance check and deployment jobs. The compliance

piece of the job works fine and the config that is going to be applied is shown, however once I highlight the job and click deploy it sits at a blank web interface for ages (hours) and then finally times out.

Any ideas?