route-inject on FWSM - can I inject to more than one interface??

[golly_wog]

Hi

I recently found the beautiful route-inject feature and thought that all my dreams had come true. However it seems that I can only inject routes to one interface, not more, I get the following message

eg:

route-inject

redistribute static access-list routes1 interface inside

redistribute static access-list routes2 interface outside

ERROR: This route-inject redistribute type is already configured.

You must first remove the previous configuration.

Am I being a doughnut, or does anyone know if it's on the road map to allow pumping routes to more than one interfaces MSFC??

cheers

[fadlouni · Accepted solution]

Hi.

Unfortunately, no there is no way to have multiple redistribute static statements. in the config guide it's mentioned that  you can have only one:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/ip_f.html#wp1140903

actually per type (static, nat, connected etc..) you can have only one.

Regards,

Fadi.

[golly_wog]

cheers