cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1770
Views
0
Helpful
6
Replies

router's security

fb_webuser
Level 6
Level 6

is there a way to point which pc cellphone or any gadgets accessed a linksys router trhu wire or wifi even if its IPs are set to automatic?

---

Posted by WebUser Betong Lim from Cisco Support Community App

1 Accepted Solution

Accepted Solutions

Anas Naqvi
Level 1
Level 1

Hi,

There are two (2) ways in checking the devices that are connected to your router.  If you have installed the Cisco Connect software, a notification under the Computers and devices section informs you of the number of devices that are connected to the router.

However, if you prefer a more detailed list, you may access the DHCP Client Table on your router’s web-based setup page where you can find the IP address, MAC address and other necessary details of the devices connected to your router.

Please also check the below link,

http://kb.linksys.com/Linksys/ukp.aspx?pid=94&vw=1&articleid=17346

View solution in original post

6 Replies 6

Anas Naqvi
Level 1
Level 1

Hi,

There are two (2) ways in checking the devices that are connected to your router.  If you have installed the Cisco Connect software, a notification under the Computers and devices section informs you of the number of devices that are connected to the router.

However, if you prefer a more detailed list, you may access the DHCP Client Table on your router’s web-based setup page where you can find the IP address, MAC address and other necessary details of the devices connected to your router.

Please also check the below link,

http://kb.linksys.com/Linksys/ukp.aspx?pid=94&vw=1&articleid=17346

fb_webuser
Level 6
Level 6

thanks, ill try, thanks a lot sir!

---

Posted by WebUser Betong Lim from Cisco Support Community App

fb_webuser
Level 6
Level 6

thanks si, got it

---

Posted by WebUser Betong Lim from Cisco Support Community App

fb_webuser
Level 6
Level 6

hi annaqvi

about my question, can we track who accessed the router and change its configuration? the list you showed me are the clients am i right?

thank you very much

---

Posted by WebUser Betong Lim from Cisco Support Community App

Yes the list was for the clients. To have detailed log history you can “LogViewer”.

For more information please check,

http://kb.linksys.com/Linksys/ukp.aspx?vw=1&docid=47b960bdf38e4470b73c4a80a0eabef3_652.xml&pid=80&respid=0&snid=3&dispid=0&cpage=search

fb_webuser
Level 6
Level 6

many thanks sir, more power!

---

Posted by WebUser Betong Lim from Cisco Support Community App

Review Cisco Networking for a $25 gift card