Network Security

If we disabled the sqlnet inspection in one firewall context, would this be applied to other contexts too?Thank youDarius.Fariborz@cgi.com                  

Hi All,Hope you are doing good,Continously I am getting below error log.Dec 07 2013 11:30:02: %ASA-7-710005: UDP request discarded from 10.109.6.1/67 to WTBB:255.255.255.255/68Dec 07 2013 11:24:00: %ASA-7-710005: UDP request discarded from 0.0.0.0/68...

Hi all,I'm having some problems with certs in a failover pair.I've imported a wildcard cert onto the primary node in a failover pair. This cert was then bound to the outside interface. This is working on the primary node fine for clientless SSL VPNs....

What is the new 8.3+ "coding" for the NAT translation below from an 8.2 ASA? I'm running 9.1.2 on a 5512Xstatic (WebTestInside,outside) tcp 172.31.0.14 https 192.168.20.14 https netmask 255.255.255.255  dnsI basically want the translation to be used ...

Hi, i am currently implementing webauth with Cisco ISE for self register, but i am having issue coa. I was able to get non-windows machine to work but with windows i can't push out the url redirection through coa.  I have enabled debug and i can see ...

we have ASA with image 9.1.3 we have given no name command .source 10.1.1.1 destination 192.168.1.1port 443 80 21 for NAT  rule we have created 3 destination object on ASA with name 192.168.1.1_80 , 192.168.1.1_443 & 192.168.1.1_21 access list only o...

We just purchased two asa firewall to be setup in an active/active configuration. But when im doing my initial configuration, the failover group command is somewhat missingASA1(config)# failover ? configure mode commands/options:  interface        ...

Hi Guyscan you help me with the following?-we have an Exchange migration project, so I will need to make changes on the firewall to allow the emails to be delivered on the new server.having a different IP address on the new server, I will need to cre...

Hi,I have an ASA5510 running version 8.2(5). I have set up a new network on interface Ethernet0/1.777 of the fwl. The firewall works perfectly with remote access VPNs but has now given me the error with the new network that has been set up:%ASA-5-305...

I am using a 5505 and  I want to know if  exist a command to show me  how much bandwith is using each ip address.or something similar. Sometimes the network works really slow. So  I want to see if someone is using to much Bandwith.

                 i would like to create a few custom reports fro my firewaal in CSM4.4 that are not derived from the default top 50 lists.What tools are used to create non canned CSM reports?i would like to be able to see all destinations visited by ...

If I have a DMZ (security 10) that I want to put a single appliance in, and I will only be accessing the device from an inside Interface (security) on port 80, I am thinking I don't need an inboud acl on the DMZ interface.Or, do I have to have one an...