09-10-2010 08:51 AM - edited 03-11-2019 11:38 AM
when sessioned to the secondary fwsm version 2.3.4, is it normal not to see ip addresses when doing a "show ip" besides 127.0.0.81 and the failoverlink ip?
09-10-2010 09:02 AM
Hello,
It sounds like you don't have standby IP addresses configured for the interfaces. You can do this with the following command under the interface config:
ip address
When you configure those, you should see them listed in the 'show ip address' output.
Hope that helps.
-Mike
09-10-2010 09:17 AM
I have all my ip address showing in the primary
System IP Addresses
ip address eobc 127.0.0.81 255.255.255.0
ip address inside 10.254.15.4 255.255.255.248
ip address WiFi-Proxydmz 10.254.50.5 255.255.255.0
ip address enterprisedmz 10.254.15.17 255.255.255.248
ip address fimsdmz 10.254.36.1 255.255.255.0
ip address failoverdmz 10.254.15.9 255.255.255.248
but if i am on the secondary, i only see:
System IP Addresses:
ip address eobc 127.0.0.81 255.255.255.0
ip address failoverdmz 10.254.15.9 255.255.255.248
Current IP Addresses:
ip address eobc 127.0.0.81 255.255.255.0
ip address failoverdmz 10.254.15.10 255.255.255.248
All my failover commands for secondary unit are in there.
09-10-2010 09:49 AM
Hi Manny,
Looks like we have a TAC case open for this together as well : ) Let's troubleshoot under the TAC case and we can post the answer for the rest of the folks once we get it solved.
-Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide