- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2017 09:08 AM - edited 03-10-2019 06:48 AM
I SSH'd into my Firesight MC server and went into shell access to check something.
However, I can't figure out how to get back into the FS IOS now
When I SSH back into the unit, it goes right into the Linux shell
Anyone have the command to get me back into the FS IOS?
Solved! Go to Solution.
- Labels:
-
IPS and IDS
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-21-2017 12:27 AM
FirePOWER Management Center (previously known as FireSIGHT Management Center or Defense Center) does not have a command line interface above the Linux bash shell.
You might be thinking of the FirePOWER service modules on an ASA - on those you enter the Linux bash shell via "expert" and leave it via "exit" commands.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-21-2017 12:27 AM
FirePOWER Management Center (previously known as FireSIGHT Management Center or Defense Center) does not have a command line interface above the Linux bash shell.
You might be thinking of the FirePOWER service modules on an ASA - on those you enter the Linux bash shell via "expert" and leave it via "exit" commands.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-21-2017 06:59 AM
Ah yes indeed. I thought I was having a senior moment lol.
thanks
