Our setup is as follows:
traffic comes into and out of the office through a 2610
The 2610 is connect to a PIX 515E. It controls the layer 3 WAN tunnels to our units.
What we would like to accomplish is to connect to one of our vendors via a 515 to 515 vpn tunnel so they can in turn connect to our unit over the WAN.
Our current support company is saying that we would need to purchase additional equipment (pix 501) to handle that one tunnel, due to the fact that the incoming traffic from the vendor cannot go out through the same interface they are coming in.
Can this be accomplished without puchasing additional equipment?
