SNMP Configuration for Firepower -2130 from FMC GUI

[netbeginner]

Hi Experts, 

We are configuring SNMP on our Firepower-2130 from Firepower management Center(FMC) GUI for Integration with NMS tool. 

--> Configured SNMP receiver (i.e. NMS Server IP) , SNMP Version : 2 , TRAPs, Assigned a Interface as well.

All details are accepted and showing properly on GUI.

But while checking and verifying the configuration on Firepower CLI, i can't find any SNMP configuration which was configured there on FMC GUI. on CLI there is nothing about snmp-server.  

Don't understand what & where i missed. 

Please advise. 

[Marvin Rhoads]

Changes you made from FMC are probably for the chassis itself. When you look at the cli you are most likely looking at the FTD running-configuration. The later won't show any FX-OS settings unless you connect to the FX-OS chassis management scope within the cli..

[netbeginner]

Hi Marvin/All, 

Could you please advise further , what to do now further in this situation..I mean where to check or change the configuration now. 

Please note that all changes on Firepower is provisioned from FMC only, we can't execute or deploy any configuration from FTD CLI .