Syslog Configuration in ASA Firewall
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2016 02:34 AM - edited 03-12-2019 01:42 AM
Will trying to configure syslog in ASA firewall, i am getting below error message.
WARNING: interface GigabitEthernet0/2 security level is 50.
WARNING: configured logging host interface conflicts with route table entry
Please let me know how to troubleshoot further.
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2016 02:48 AM
Hello,
Can you please attach following outputs:
show run logging
show route
show ip
show logging
also provide software version running on firewall and the hardware model.
Can you please also confirm that logs are actually not being received at all. This might be a cosmetic issue afterall.
HTH
-
AJ
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2016 03:05 AM
This is not an error, it's only a warning. As the interface is configured with Security-level 50, the ASA assumes that it might be an untrusted network you are sending your valuable logs to. If the rest of the config is correct, it will also work over this interface.
