Network Security

Hello, I'm currently trying to set up a new router in my company's network. Everything works fine concerning Internet access, unfortunately my company is using a software which has to go through a VPN (another Cisco router) using a static route, and ...

Hi all,   I can't apply the newly create SSL policy to Access Control Policy, as it prompt the error message as "SSL Inspection is not supported on one or more of the targeted devices"   Apparently this error message it too generic, i not really sur...

Hello Previously I have adjusted the interface from -------- original version -----interface GigabitEthernet0/2 speed 1000 duplex full nameif outside security-level 0 ip address 111.222.333.2 255.255.255.248!interface Port-channel1 duplex full lacp ...

We have purchased some additional external IP addresses from our ISP as we've used all the statics on the external inferface of our ASA5525  So I now have 2 blocks of IP addresses, the first is configured on the external interface and I need a way o...

Hi, I want all my vlans access to the internet, unfortunately it failed. as i see i am having problem with my routing on the  asa. what is the right command that i will use. my static route is "outside.any.any.public ip". thank you! Regards, Philber...

Hello guys, I have a ASA 5540 that I'd like to configure for my brand office. Below my network topology: Comcast---->Cisco ASA 5540 ----> L3 switch----> PC.  The ASA 5540 is reset to factory default setting. The goal is that I'd like to get my PCs o...

Hi, I was wondering about the fact, that a FMC v6.0.1 installation says, it does not need any FMC licenses any more? So am I right, that in future there is no need to buy such licences? Do we need to buy service for the FMC or is it included in the ...

Hello,                                                                  we've implemented Cisco ASA CTP on Cisco ASA 5520. We've noticed that on page https://CTPlogin.mydomain.com:5601/netaccess/connstatus.html if we intentionally mistake user or pas...

Hello everyone! I am about to downgrade an ASA 5510 pair from 9.1(1) to 8.2.5(59) and I have a things to ask. - Both units on failover active/standby mode with SSM AIP module (version 7.1(8) E4): is there going to be a problem the module version??...

If i view a connection event that is showing up with an action of "block" can i on the fly enable just that connection without white listing the ip for all connections?