Hello,
I have a Tandberg DPS 2000 that I was in the process of restoring to factory defaults remotely, and I lost power
in the house and thus lost my connecton to the Tandberg.
I have reconnected to the Tandberg, so the network settings are still in place, but, when I enter the admin password
using the default TANDBERG password, I keep getting denied.
It has been 3 hrs. and I still cannot get logged in..could it be that it is still restoring and has locked me out until the
process is over?
At any rate, this is where I am stuck. I am looking for a way to again gain access to the Tandberg and finish my
configuration, so any help would be most appreciated.
thanks,
Tony