02-04-2008 12:46 AM - edited 03-11-2019 04:58 AM
Can anyone recommend the best way to run a regular failover test for a pair of ASA firewalls running in Active/Standby please?
Is it just a case of making the active unit a standby?
Solved! Go to Solution.
02-04-2008 03:04 AM
Hi,
Yes it is making active unit a standby.
1 power down the active unit to force failover to the standby unit
2 check the connectivity through standby
3 and power on the active unit.
or give (in pix os 6.3)
on primary device:
primary(config)#no failover active
check the connectivity through standby
after bring back active device by issuing below command on standby device
secondary(config)#failover active
regards
skrao
02-04-2008 03:04 AM
Hi,
Yes it is making active unit a standby.
1 power down the active unit to force failover to the standby unit
2 check the connectivity through standby
3 and power on the active unit.
or give (in pix os 6.3)
on primary device:
primary(config)#no failover active
check the connectivity through standby
after bring back active device by issuing below command on standby device
secondary(config)#failover active
regards
skrao
02-04-2008 03:07 AM
Thanks Skrao, just what I needed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide