09-19-2007 11:17 AM - edited 03-11-2019 04:13 AM
I have a VPN peer that cannot connect to my end all of the sudden.
"debug cry isakmp" shows no attempt at all for the tunnel to try and come up from the remote end.
They will be initiating the traffic and do not allow us to initiate to them.
There is another tunnel in my PIX that is up and wotking.
How can I clear the tunnel without blowing it out of the config?
will "clear crypto sa peer x.x.x.x" do it without removing it from the config?
09-20-2007 04:39 AM
The command "clear crypto sa peer x.x.x.x" will indeed remove the 'active' vpn tunnel without removing anything from the configuration.
More information can be found here:
http://www.cisco.com/en/US/docs/ios/12_2/security/command/reference/srfipsec.html
Regards,
Michael
09-20-2007 04:41 AM
(Something went wrong: posted the same reply twice!)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide