Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
856
Views
0
Helpful
1
Replies

Unable to apply Access Control Policy.

Cory Brown
Level 1
Level 1

‎11-09-2016 05:48 PM - edited ‎03-10-2019 06:42 AM

This sensor (3D7020) was recently updated to 5.3.0.8 and i am unable to apply any Access Control Policy, even a blank one.  Health and System policies apply with no problems.  I am not seeing a specific errors in /var/log/messages.  Is there anywhere else to scan for errors that may help me resolve this issue?

Labels:
0 Helpful
1 Reply 1

Oliver Kaiser
Level 7
Level 7

‎11-10-2016 02:55 PM

You might wanna check /var/log/action_queue.log on both fmc and sensor for further error information. If deploy fails it is mostly due to some bad reference resulting in an abort of deployment that is caused by a bug.

If you do not find anything do not hesitate to contact TAC or try upgrading to a newer version.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card