cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3964
Views
0
Helpful
3
Replies

Unable to communicate with dynamic analysis cloud

Mark^
Beginner
Beginner

I have two interfaces on Defense Center.  One of them (eth1) is on a management vlan that does not have Internet access.  When AMP tries to connect to cloud it frequently tries via eth1 and I get the above message and a health monitoring alert.  I know this is the cause because it shows the IP address of eth1 in the message and, as I said, eth1 does not have Internet access.

How do I force updates to only use eth0?  My default route is on eth0 network.

Mark
3 Replies 3

Mark^
Beginner
Beginner

I am actually getting a similar message when eth1 is not present, though it is less frequent.

Mark

jlimmer14
Beginner
Beginner

did you ever find an answer?

Negative, but I think I misunderstood the problem in the first place.  I am now on 6.0 and get the message once in a while, but it never causes a health monitoring alert and doesn't seem to cause any other issue.

Mark
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers