cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
0
Helpful
3
Replies

Unable to exclude host from QoS Policy

ABaker94985
Spotlight
Spotlight

We have a 4110 Firepower running 7.0.2 managed by FMCv also running 7.0.2. We've had a couple recent events where Adobe released updates and our Internet bandwidth was impacted. An update server has been created, so I'm trying to exclude this server from the QoS policy as shown in the attached image. Unfortunately, the deployment fails with the following error:

Deployment failed. Correct configuration error(s) and redeploy. If deployment fails again, contact Cisco TAC

Nov 2 10:21:15 Expected space at line number 89: .
Failed to parse qos rules file -1

Any ideas what we need to try? Thank you.

1 Accepted Solution

Accepted Solutions

Try changing the source and destination interface objects to inside-group and outside-group.

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

3 Replies 3

Try changing the source and destination interface objects to inside-group and outside-group.

--
Please remember to select a correct answer and rate helpful posts

ABaker94985
Spotlight
Spotlight

Thank you so much. I completely missed that the previous configuration was set that way, but deployment worked as normal.

Glad I could help out, and thanks for rating the solution.

--
Please remember to select a correct answer and rate helpful posts
Review Cisco Networking for a $25 gift card