Voice over PIX VPN?

mikeb · ‎08-10-2006

I have a LAN2LAN VPN between a PIX 501 and 3030. I want to be able to connect a phone at the remote site. The tunnel is up and I can ping the phone but it doesn't connect to the CM. Is there something I have to configure on the PIX to allow the phone to connect?

Any help is appreciated.

Thanks

spremkumar · ‎08-14-2006

Hi

Though i am not sure about the ports being used by CM would suggest to check the same and open up the same in PIX end so that you can establish the connectivity with the CM..

regds

timothymm · ‎08-17-2006

You can also try telneting to the phone / CM from each end once you have to ports worked out. that way you can test the connectivity at that port. You should also have a traffic monitor on the CM so you can see if the phone is actually trying to register.

Tim